DAS NX-148E LCD Codepad Manuel d'utilisateur télécharger pdf (Page 17)

READING THE EVENT LOG

The control panel has an event log that can be retrieved using a master code. This

log contains a listing of the events along with date, time, and partition where the

event occurred.

Step 1 To view the log, press r 9 0 . The LCD screen will prompt you

for a code.

Step 2 Enter your master code. The LCD screen will now show the most recent

event.

Step 3 To view the events from most recent to the oldest, press – .

Step 4 To view the events from the oldest to the newest, press • . The display

contains the following information.

Event ¼ » User or Zone ID

Date ¼ » Indicates partition

Open 75

9/25 17:57 P3*

(Month/Day)

ü Time shown in and À indicates an

24-hour format event not reported

This screen shows an opening of Partition 3 on September 25

at 5:27 p.m. by

user 75. The [r] shows that this event is not programmed to be reported to the

central monitoring station. Refer to Appendix A on page 23 for a list of possible log

messages.

ADJUSTING THE VIEW / BRIGHTNESS OF THE LCD

Step 1 Enter r 9 1 . The LCD Screen will prompt for a code.

Step 2 Enter [master code]. The LCD will now prompt you to raise or lower the

view.

Step 3 Using the – • scroll keys to the right of the LCD, you can raise or

lower the viewing angle of the text.

Step 4 To advance to the Brightness option, press r The LCD will prompt you

to brighten or dim the LCD lighting. Use the scroll keys again to adjust to

desired brightness.

Step 5 When completed, exit by pressing r

Hills LCD Keypad

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Pas de commentaire

DAS NX-148E LCD Codepad Manuel d'utilisateur Page 17