DAS NX-148E LCD Codepad Manuel d'utilisateur télécharger pdf (Page 13)

TEST FUNCTION (Optional, if programmed)

If programmed, this function will perform a battery test, communicator test,

and/or a siren test. No alarms will be sent, and no reports will be sent unless

a communicator test is performed, in which case a test signal will be sent.

Step 1 Press . The test will be performed as programmed.r 4

Step 2 If the siren test is performed, enter a user code to silence the siren.

CHANGING USER CODES

Step 1 Press . The LCD Screen will prompt for a code.r 5

Step 2 Enter [master code]. The LCD Screen will prompt for a user

number. NOTE: For partitioned systems, if you are changing the

code of another person, you must have access to all partitions, or

at least all of the partitions to which the other person has access.

Step 3 Enter the 2 digit user number (always 2 digits, i.e. "03" for user 3).

The LCD screen will prompt for a new code. NOTE: To delete a user

code, press [Chime]-[Chime]-[Chime]-[Chime] for a 4-digit code or

[Chime]-[Chime]-[Chime]-[Chime]-[Chime]-[Chime] for a 6-digit

code.

Step 4 Enter the new user code designated for that individual. If it rejects

the code because of a duplication or such, the sounder will beep 3

times.

Step 5 If another user code needs to be programmed, return to step 3 and

enter the user code.

Step 6 To exit Code Programming, press while the LCD screen is#

prompting for a new user.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

Pas de commentaire

DAS NX-148E LCD Codepad Manuel d'utilisateur Page 13