DAS NX-148E LCD Codepad Manuel d'utilisateur télécharger pdf (Page 18)

Open 75

9/25 17:57 P3rr

RESET FUNCTION

This function is used to reset Smoke Detectors, Zone Troubles, and Zone

Tampers.

Step 1 Disarm the system if it is not already disarmed.

Step 2 Press . Resets have now been performed.r 7

Step 3 If the code pad begins beeping, the reset did not execute properly.

Enter your code to silence the code pad. Wait a few minutes and

repeat step 2 to attempt another reset. If the code pad still beeps after

repeated attempts, please contact your installer.

READING THE EVENT LOG

The NX-16 has a 185 event log that can be retrieved using a master code. This

log contains a listing of the last 185 events along with date, time, and partition

where the event occurred.

Step 1 To view the log, press . The LCD screen will prompt your 9 0

for a code.

Step 2 Enter your master code. The LCD screen will now show the most

recent event.

Step 3 To view the events from most recent to the oldest, press the

–

down scroll key.

Step 4 To view the events from the oldest to the newest, press the up

•

scroll key. The display contains the following information.

Event º » User or Zone ID

Date º » Indicates partition

(Month/Day) ü Time shown in and rr indicates an

24 hour format event not reported

This screen shows an opening of Area 3 on September 25 at 5:27 p.m. by user

75. The [rr] shows that this event is not programmed to be reported to the

central monitoring station.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 32 33

Pas de commentaire

DAS NX-148E LCD Codepad Manuel d'utilisateur Page 18